Solar Power Manager V1.0 for 9V/12V/18V Solar Panel

The DFRobot Solar Power Manager charges a single 3.7 V lithium cell (Li-ion or LiPo) with up to 2 A from a 7 to 30 V solar panel, via USB or via a power supply. The LTC3652 charge controller keeps the solar panel close to its maximum power point (MPPT); the voltage is set to 9, 12 or 18 V with a DIP switch. Three regulated outputs can be switched individually: 5 V 1.5 A, 3.3 V 1 A and either 9 V or 12 V with 0.5 A, plus a 5 V USB output. The battery is not included.


Recommended Accessories:


Features:

  • Constant voltage MPPT, set via DIP switch: panel with 9 to 11.9 V on 9V, 12 to 16.9 V on 12V, 17 to 24 V on 18V, or MPPT off
  • Solar panels up to 20 W recommended, SOLAR IN at most 30 V
  • Charging via SOLAR IN, via Micro-USB (5 V 2 A adapter recommended) or via a 7 to 30 V power supply on SOLAR IN with MPPT off; USB has priority
  • Three-phase charging: trickle charge below 2.94 V, constant current up to 2 A, constant voltage up to 4.2 V, recharge below 4.1 V
  • Battery input BAT IN as PH2.0 socket and as 5.08 mm screw terminal, both connected internally, connect only one cell
  • Choose a battery with at least 2000 mAh at 1C charge rate or a battery with its own protection circuit
  • OUT1 to OUT3 on via jumper, or remove the jumper and switch EN with a microcontroller pin (HIGH on, LOW off, 3.3 V and 5 V logic)
  • USB output is always on, OUT1 and USB share 5 V 1.5 A
  • From the battery alone the outputs deliver about 9.4 W together, more via USB IN or SOLAR IN
  • With a power supply or a solar panel of 10 W or more, stick the heat sink with the thermal pad onto the Cooling Fin area on the bottom
  • BOOT button: press once after changing the battery or after a protective shutdown

Application Examples:

  • Solar-powered measuring stations and sensor nodes
  • Small solar lamps and robots
  • Power bank with solar and USB charging
  • Low-power operation: switch sensors on via EN only for measuring

Documentation:


Technical Data:

  • Manufacturer: DFRobot
  • Manufacturer SKU: DFR0535
  • Charge controller: LTC3652
  • Solar input SOLAR IN: 7 to 30 V
  • MPPT settings: off, 9 V, 12 V, 18 V
  • USB IN: 5 V via Micro-USB
  • Battery BAT IN: one 3.7 V Li-ion or LiPo cell
  • Charging current: up to 2 A
  • Charge termination voltage: 4.2 V ±1 %
  • Outputs: OUT1 5 V 1.5 A (with USB OUT), OUT2 3.3 V 1 A, OUT3 9 V or 12 V 0.5 A
  • Output efficiency at 50 % load from 3.7 V: OUT1 86 %, OUT2 92 %, OUT3 (9 V) 89 %
  • Charging efficiency: USB 84 % at 1 A, solar (18 V) 78 % at 1 A
  • Quiescent current: below 3 mA
  • Protection BAT IN: overcharge 4.3 V, over-discharge 2.4 V, overcurrent 3 A, reverse polarity
  • Protection outputs: short circuit, overcurrent, overtemperature
  • Protection SOLAR IN: reverse current, reverse polarity
  • Operating temperature: -40 °C to 85 °C
  • Dimensions: 78 × 68 × 12 mm
  • Weight: 64 g

Scope of Delivery:

  • 1× Solar Power Manager V1.0 for 9V/12V/18V Solar Panel
  • 3× Jumper black
  • 4× Nylon standoff M3
  • 4× Stainless steel screw M3
  • 1× Aluminium heat sink 14 × 14 mm
  • 1× Thermal pad 14 × 14 mm
  • 1× Adapter DC socket to screw terminal

Write a review

Note: HTML is not translated!
    Bad           Good

Solar Power Manager V1.0 for 9V/12V/18V Solar Panel

  • Brand: DFRobot
  • Product Code: 421793
  • Availability: In Stock
  • CHF36.90

  • Ex Tax: CHF34.14

Related Products

18650 Battery Compartment / Battery Holder with Connection Cable

18650 Battery Compartment / Battery Holder with Connection Cable

This battery holder is suitable for one 18650 Li-Ion / LiPo battery. The already stripped connection..

CHF2.90 Ex Tax: CHF2.68

MPPT Solar Power Management Module for 6V-24V Solar Panel

MPPT Solar Power Management Module for 6V-24V Solar Panel

The module from Waveshare charges a 3.7 V Li-Ion battery from a 6 V to 24 V solar panel or via USB a..

CHF14.90 Ex Tax: CHF13.78

DFRobot Solar Power Manager 5V 1A

DFRobot Solar Power Manager 5V 1A

The DFRobot Solar Power Manager 5V charges a single 3.7 V lithium cell with up to 900 mA from a 5 V ..

CHF13.90 Ex Tax: CHF12.86

DFRobot Solar Power Manager for 12V Lead Batteries

DFRobot Solar Power Manager for 12V Lead Batteries

The DFRobot Solar Power Manager charges a 12 V lead-acid battery with up to 4 A from an 18 V solar p..

CHF29.90 Ex Tax: CHF27.66

18V 0.61A Monocrystalline Solar Panel 10W

18V 0.61A Monocrystalline Solar Panel 10W

This 18V 10W solar panel is mounted in a sturdy aluminum frame. The cells themselves are laminated w..

CHF32.90 Ex Tax: CHF30.43

Solar Power Manager (C) for 6-24V Solar Panel

Solar Power Manager (C) for 6-24V Solar Panel

This is a Solar Power Manager from Waveshare. The Power Manager supports panels from 6-24V, thus cha..

CHF23.90 Ex Tax: CHF22.11

LilyGo TTGO T-BAT 18650 Battery Holder with CN3065 Solar Power Manager

LilyGo TTGO T-BAT 18650 Battery Holder with CN3065 Solar Power Manager

The LilyGo T-BAT combines a solar charge controller with the CN3065 chip and a battery holder for on..

CHF12.90 Ex Tax: CHF11.93

DFRobot 3.7V Solar Li-Po Charge Controller

DFRobot 3.7V Solar Li-Po Charge Controller

The solar charge controller from DFRobot charges a single-cell lithium battery (3.7 V) from a solar ..

CHF6.90 Ex Tax: CHF6.38

Solar Lipo Charger with USB 5V 1A V2.3

Solar Lipo Charger with USB 5V 1A V2.3

This solar charge controller charges a 3.7 V lithium battery from a 5 V solar panel or via the mini ..

CHF10.90 Ex Tax: CHF10.08

MPPT Solar Power Management Module (D) for 6V-24V Solar Panel

MPPT Solar Power Management Module (D) for 6V-24V Solar Panel

The MPPT Solar Power Management Module (D) is the perfect solution for projects requiring efficient ..

CHF16.90 Ex Tax: CHF15.63

18V 0.6A Semi-flexible polycrystalline solar panel 10W with USB port

18V 0.6A Semi-flexible polycrystalline solar panel 10W with USB port

The semi-flexible 18V 10W polycrystalline solar module offers you a lightweight and portable solutio..

CHF34.90 Ex Tax: CHF32.28

10W Solar Power Kit 12V / 5V Outputs monocrystalline panel

10W Solar Power Kit 12V / 5V Outputs monocrystalline panel

This DFRobot solar kit powers measuring stations and IoT devices outdoors without a mains connection..

CHF46.90 Ex Tax: CHF43.39

LilyGo T-Solar Kit

LilyGo T-Solar Kit

The LilyGo T-Solar Kit is a complete solution for solar-powered power supply of compatible LilyGo de..

CHF39.90 Ex Tax: CHF36.91

Tags: Solar, 5V, Charge controller, MPPT, Solarcharger, IOT, Battery, LiPo, low power, Cell, Solar cell, Li-po, 3.7v, 3.3V, Charger, Charger, Charging electronics, Sunflower, Sun, Solar energy, Battery, 1A, Battery operation, Battery operation, JST, PH, PH2.0, 2.0, Lithium, Li-Ion, DFRobot, LTC3652, DFR0535, solar charge controller