Creality Silent Mainboard V2.2 with Ender 5 Plus Firmware

With this retrofittable Creality Silent Mainboard V2.2.1, you can massively improve the noise generation during printing, which is caused by the drivers of the stepper motors. After upgrading to the Silent Mainboard, the motors are hardly audible. The firmware for the Ender 5 Plus is already installed on the mainboard, and a bootloader is present. If you want to use the board on another printer, you can directly flash another firmware via USB with the Arduino IDE. The conversion to the new board is done in approx. 40 minutes. Before the conversion, take a photo of how the plugs are connected. When reconnecting the new board, it makes your work easier.

Info Firmware: Creality has new firmware on the mainboards, therefore it may be necessary that you have to flash the display firmware and possibly also the board firmware anew. You can find the firmware under the download below. The Hexfile for the mainboard can be uploaded most easily with the X-Loader. Simply select the Hex file from the Zip in the X-Loader and for the Device, select "Mega(ATMEGA2560)". Afterwards, you only need to select the correct Com Port and upload the firmware.

Characteristics Creality Silent Mainboard V2.2:

With the new TMC2208 driver, noise development from the motors is hardly audible.
Firmware for Ender 5 Plus is pre-installed
Bootloader is pre-installed (ISP/USB Arduino).
Suitable for Ender-3 / Ender-3 Pro / Ender-5 / Ender-5 Pro / CR-10 (Appropriate firmware must be installed).