32-Bit Creality Silent Mainboard V4.2.7 with Ender 3 V2 Firmware

With this retrofittable 32-Bit Silent Mainboard V4.2.7, you can massively improve the noise development during printing, which is caused by the drivers of the stepper motors. After upgrading to the Silent Mainboard, the motors are barely audible. The firmware for the Ender 3 V2 Firmware is already flashed on the mainboard and a bootloader is present. If you want to use the board on an Ender 3, Ender 5 pro or CR-10, you can directly flash another firmware via the Micro SD card. The conversion to the new board takes about 40 minutes. Before the conversion, it is advisable to take a picture of how the plugs are connected. This will make it easier for you to reconnect the new board.

Features of the 32-Bit Creality Silent Mainboard V4.2.7:

With the new TMC2225 driver, hardly any noise development is audible at the motors.
Separate connector for filament runout sensor
Seperate connector for BLTouch sensor
Easy firmware update possible via SD card thanks to the 32-Bit mainboard
Suitable for Ender-3 / Ender-3 Pro / Ender-5 / Ender-5 Pro / CR-10 (correct firmware must be installed)