OLED Display 128x128 1.5\" white I2C SPI

This Waveshare OLED display with 1.5 inches and 128 × 128 pixels shows 16 grey levels and is controlled via SPI or I2C. It runs on Arduino, ESP8266 or ESP32 because it can be operated at 3.3 V and 5 V. Thanks to its low power consumption it is also suitable for battery-powered applications. Ready-made libraries are available for control.

Recommended alternative in colour: 128x128 1.5inch RGB OLED Display Module SPI

Recommended Accessories:

• Dupont Cables M-M 10cm 20 Pieces

Features:

• SSD1327 driver
• Factory setting 4-wire SPI; for I2C the BS resistor on the back is re-soldered
• The supplied cable plugs directly onto a Raspberry Pi; for Arduino UNO or breadboard 7 additional male/male Dupont wires are needed
• Library: U8g2 or example code from Waveshare for Arduino, STM32 and Raspberry Pi

Application Examples:

• Display of measured values and status
• Menus in small devices
• Mobile, battery-powered projects

Documentation:

• Waveshare Wiki 1.5inch OLED Module
• U8g2 library (GitHub)

Technical Data:

• Manufacturer: Waveshare
• Manufacturer SKU: 13992
• Driver IC: SSD1327
• Operating voltage: 3.3 V / 5 V DC
• Resolution: 128 × 128
• Grey levels: 16
• Display size diagonal: 1.5"
• Colour: White on black
• Interface: 4-wire SPI (default) or I2C, via BS resistor
• Connections: VCC, GND, DIN, CLK, CS, DC, RST
• BS 0, 4-wire SPI: DIN = MOSI, CLK = SCK
• BS 1, I2C: DIN = SDA, CLK = SCL
• I2C address: 0x3D according to Waveshare, 0x7A in 8-bit notation
• Arduino UNO: DIN D11, CLK D13, CS D10, DC D7, RST D8
• Viewing angle: over 160°
• Dimensions: 45 × 37 × 9.5 mm
• Weight: 23 g

Scope of Delivery:

• 1× OLED display 128x128 1.5" white I2C SPI
• 1× Cable PH2.0 to 1×7-pin female Dupont 20 cm