1.54\" 240x240 IPS TFT LCD Display with MicroSD

The display module from DFRobot has a 1.54 inch IPS display with 240 × 240 pixels, driven by the ST7789 via SPI. There is also a slot for microSD cards, for example for images. It runs on 3.3 to 5 V with Arduino UNO, Leonardo, ESP32, ESP8266 and FireBeetle. On the FireBeetle ESP32-E and M0 it is connected via the GDI socket with the included flat cable, without single wires.

Recommended Accessories:

• 8GB MicroSDHC memory card Class 10 UHS-I incl. SD adapter
• FireBeetle 2 Board ESP32-E
• FireBeetle Board ESP32-E with soldered socket strips

Features:

• IPS display, viewing angle 80° in all directions
• 240 × 240 pixels, 16-bit colour (RGB565)
• 4-wire SPI or GDI socket for FireBeetle
• microSD card slot
• Backlight switchable via the BL pin

Application Examples:

• Small display for readings and clocks
• Showing images from the microSD card
• Status display for FireBeetle projects

Documentation:

• DFRobot Wiki DFR0649
• DFRobot_GDL library (GitHub)

Technical Data:

• Manufacturer: DFRobot
• Manufacturer SKU: DFR0649
• Operating voltage: 3.3 to 5 V
• Driver chip: ST7789
• Resolution: 240 × 240 pixels
• Pins: VCC, GND, SCLK, MOSI, MISO, CS, RES, DC, BL, SDCS
• Brightness: 250 cd/m² typical
• Current full screen: about 17 mA at 3.3 V and at 5 V
• Operating temperature: -30 to 70 °C
• Display area: 27.72 × 27.72 mm
• Mounting holes: 2 mm, spacing 40 × 35 mm
• Dimensions: 44 × 39 × 3.7 mm
• Weight: 19 g

Scope of Delivery:

• 1× 1.54" 240x240 IPS TFT LCD display with MicroSD
• 1× Pin header 1 × 10
• 1× GDI flat cable FPC 0.5 mm 18-pin, 10 cm, for FireBeetle M0 or ESP32-E