128x128 1.5inch RGB OLED Display Module SPI

This Waveshare colour OLED display with 1.5 inches and 128 × 128 pixels shows 65K colours and is controlled via SPI. It runs on Arduino, ESP8266 or ESP32 because it can be operated at 3.3 V and 5 V. Ready-made libraries are available for control.

Recommended alternative in white, also with I2C: OLED Display 128x128 1.5" white I2C SPI

Recommended Accessories:

• Dupont Cables M-M 10cm 20 Pieces

Features:

• SSD1351 driver
• SPI only: factory setting 4-wire SPI; for 3-wire SPI the BS resistor on the back is re-soldered and DC is connected to GND
• Supply and logic must have the same voltage
• The supplied cable plugs directly onto a Raspberry Pi; for Arduino UNO or breadboard 7 additional male/male Dupont wires are needed
• Current consumption according to Waveshare at 3.3 V: about 60 mA with an all-white image, 4 mA with an all-black image
• Library: Ucglib or example code from Waveshare for Arduino, STM32 and Raspberry Pi

Application Examples:

• Colour display of measured values and symbols
• Menus in small devices
• Small games and animations

Documentation:

• Waveshare Wiki 1.5inch RGB OLED Module
• Ucglib library (GitHub)

Technical Data:

• Manufacturer: Waveshare
• Manufacturer SKU: 14747
• Driver IC: SSD1351
• Operating voltage: 3.3 V / 5 V DC
• Connection: Pluggable via PH2.0 7-pin or solder connection
• Resolution: 128 × 128
• Display colour: RGB, 65K colours
• Display size diagonal: 1.5"
• Display area: 26.855 × 26.855 mm
• Interface: 4-wire SPI (default) or 3-wire SPI, via BS resistor
• Connections: VCC, GND, DIN, CLK, CS, DC, RST
• Arduino UNO: DIN D11, CLK D13, CS D10, DC D7, RST D8
• Viewing angle: over 160°
• Dimensions: 45 × 37 × 9.4 mm
• Weight: 26 g

Scope of Delivery:

• 1× 128x128 1.5inch RGB OLED display module SPI
• 1× Cable PH2.0 to 1×7-pin female Dupont 20 cm