Resin Water Washable Grey 0.5Kg UV 405nm eSun

The grey eSun Water Washable Resin can be washed off with water after printing. Cleaning with isopropanol, as with standard resin, is not needed. The resin is intended for LCD and DLP resin printers at 395 to 410 nm and is supplied in a light-tight aluminium bottle.

Recommended Accessories:

• Nitrile Protective Gloves L 100-pack
• Creality Resin Filter 20 Pieces
• eCure Lite Foldable Resin Curing System

Features:

• Printed parts are cleaned with water
• Low odour
• For LCD and DLP printers at 395 to 410 nm
• Shore hardness 76D, scratch resistant
• Good moisture resistance
• Light-tight aluminium bottle for long storage
• After printing, wash under running water and let air dry
• Then post-cure under UV light until final strength is reached, with UV LEDs or 2 to 3 hours in sunlight
• Shake before use, not too hard so that no air bubbles form. Avoid direct sunlight during processing
• Wear gloves, ventilate the room well, keep away from children, in case of skin contact wash immediately with plenty of water

Application Examples:

• Models and figures
• Prototypes with fine details
• Printing without cleaning in alcohol

Documentation:

• Water Washable Resin instructions (PDF)

Technical Data:

• Manufacturer: eSun
• Type: eResin-LC1000 Water Washable H05
• Colour: Grey
• Content: 500 g
• Wavelength: 395 nm to 410 nm
• Storage temperature: 15 °C to 35 °C
• Density: 1.05 g/cm³ to 1.25 g/cm³
• Viscosity at 25 °C: 100 mPa·s to 200 mPa·s
• Flexural strength: 68 MPa
• Flexural modulus: 900 MPa to 1400 MPa
• Tensile strength: 45 MPa to 70 MPa
• Elongation at break: 5 % to 10 %
• Hardness: 76 Shore D
• IZOD impact strength: 18 J/m to 39 J/m

Scope of Delivery:

• 1× Resin Water Washable Grey 500 g