Gravity Non-contact Digital Water/Liquid Level Sensor for Arduino

This XKC-Y25-T12V is a non-contact water/liquid level sensor for Arduino. It uses advanced signal processing technology with a powerful chip (XKC-Y25-T12V) and capacitance measurement principle to achieve non-contact level detection. The module is suitable for hazardous applications such as detecting toxic substances, strong acids, strong alkalis, and all types of liquids in airtight containers under high pressure due to its non-contact measurement capability. The sensor cannot be used with metal containers, but there are no special requirements for the liquid. The liquid sensor is easy to use and install. The level sensor is equipped with an interface adapter that is compatible with the DFRobot Gravity interface. Four sensitivity levels can be configured by pressing the SET button.

Note: You can reverse the connection cable by attaching a Dupont cable M-M 10cm to male, so that you can easily use it on an Arduino UNO.

Documentation:

• DFRobot Wiki
• User Manual

Technical Details: 

• Chip: XKC-Y25-T12V
• Not suitable for metallic containers
• Interface: Gravity Digital
• Operating Voltage (InVCC): 5 to 24V DC
• Power Consumption: 5mA
• Output Voltage (High Level): InVCC
• Output Voltage (Low Level): 0V
• Output Current: 1 to 50mA
• Response Time: 500ms
• Operating temperature: 0 to 105°C
• Material: ABS
• Sensor Diameter: 23mm
• Sensor Height: 16.9mm
• Weight: 29.5g

Scope of Delivery:

• 1x Gravity Non-contact Digital Water / Liquid Level Sensor for Arduino
• 1x Adapter Board
• 1x Gravity 3pin digital sensor cable PH2.0 to XH2.54