Gravity 4pin IIC/I2C/UART Sensor Cable for Arduino 10 Pieces

These IIC/I2C/UART sensor cables from DFRobot connect IIC/I2C/UART Gravity sensors to an IO Expansion Shield. They fit most IIC/I2C/UART Gravity sensors and IO boards.

With pins instead of a Dupont socket: Gravity 4pin IIC/I2C/UART PH2.0 to Dupont Male Cable 30cm 10pcs

Recommended Accessories:

• Gravity IO Expansion Shield for Arduino V7.1
• Gravity I2C HUB
• Dupont Cables M-M 10cm 20 Pieces

Features:

• PH2.0 housing for the sensor, 4-pin Dupont socket for the board
• A Dupont cable M-M adapts the Dupont socket to pins, for example for the socket headers of an Arduino UNO
• With UART, check the direction of TX and RX on the connected device

Application Examples:

• Connecting Gravity sensors to an IO Expansion Shield
• Connecting Gravity sensors to an Arduino UNO via a Dupont cable M-M

Technical Data:

• Manufacturer: DFRobot
• Manufacturer SKU: FIT0513
• Pin assignment: red VCC power, black GND, blue SCL or TX, green SDA or RX
• Maximum voltage: 50 V
• Maximum current: 1000 mA
• Connector: 4-pin JST PH2.0 / 4-pin Dupont socket 2.54 mm pitch
• Length: 30 cm
• Set weight: 45 g

Scope of Delivery:

• 10× sensor cable 30 cm