50kg Load Cell Weight Sensor

This load cell and an HX711 load cell amplifier can be used to build scales and other weight measurements with an Arduino. A single cell is a half bridge with 3 wires. Up to four cells can be combined, allowing up to 200 kg to be measured.

Recommended Accessories:

• Load Cell Amplifier - HX711 Weighing Sensor 24 Bit
• Dupont Jumper Cable Set 20cm 60 Pieces.

Features:

• Half bridge with 3 wires
• Circuit diagram of the cell and connection diagram for four cells are in the image gallery
• Four cells together form a full bridge for the HX711

Application Examples:

• Bathroom scales and platform scales
• Measuring weight and weight changes

Documentation:

• Bathroom scale with 50 kg cells and HX711 (Instructables)
• HX711 hookup guide (SparkFun, different module with the same chip)

Technical Data:

• Maximum weight per cell: 50 kg
• Resistance: 2× 1 kΩ
• Wires of this cell according to the diagram: white and black at the ends, red in the middle
• Connection to the HX711: wire four cells into a full bridge, connection diagram in the image gallery. If the reading falls under load, swap A+ and A-
• Connection wire length: 40 cm
• Dimensions: 34 × 34 × 9 mm
• Weight: 19 g

Scope of Delivery:

• 1× 50kg Load Cell Weight Sensor