9g 300° Servo with Slip Clutch

With servos, it can happen that if the mechanical load is greater than the specification, it can lead to damage to the gearbox or overheating. With these special clutch servos with a clutch function and electronic protection, no more overload or damage can occur. If the angle of a servo is changed by external forces during normal operation, the servo can be automatically reset and continue working through the clutch function, which prevents damage. The additional electronic protection switches off the blocked servo after 5 seconds to avoid overheating. This servo has a large torque, stable performance, accurate running angle and is easy to install. When the servo is powered at 6V, it reaches its stall torque of 1.2Kg/cm. There is no limited stop inside the servo, so it can rotate smoothly in 360 degrees (manual only). You can control the servo with the servo libraries from your Arduino IDE and drive it over a maximum 300-degree swing within the pulse range of 500-2500μsec.

Servo plug assignment:

Technical details:

• Operating voltage: 4.8 to 6V DC
• Type: DS-S006L
• Communication: PWM
• Operating angle: 300°±10°
• Pulse width range: 500 to 2500μs
• Static current: ≤8mA at 6.0V
• No-load current: ≤50mA at 4.8V ≤60mA at 6.0V
• Stall current: ≤550mA at 4.8V ≤650mA at 6.0V
• Rated torque: ≥0.32kg cm at 4.8V ≥0.4kg cm at 6.0V
• Stall torque: ≥1kg cm at 4.8V ≥1.2kg cm at 6.0V
• Dimension: 32.5 x 12 x 27.3mm
• Weight: 15g

Package includes:

• 1x 9g 300° Servo with slip clutch
• 1x Servo lever set