Panel Mount Push Button Red 7mm 2P

This red push button is mounted in a 7 mm hole in a housing or front panel and closes the contact when pressed. With the pull-up resistor enabled on the Arduino, the button is connected to an input and GND: when not pressed the signal is 1, when pressed it drops to 0.

Features:

• Normally open contact, connection via 2 solder tabs
• Mounting with nut and spring washer
• When soldering, do not apply too much heat for too long, otherwise the plastic melts and the button is destroyed

Application Examples:

• Control button in housings and front panels
• Input for Arduino and other microcontroller projects

Documentation:

• Push button on the Arduino with pull-up and debouncing (Robotics Back-End)

Technical Data:

• Colour: red
• Material: plastic / galvanised metal
• Switching contact: NO (normally open)
• Contact: soldering
• Number of pins: 2
• Maximum voltage: 50 V
• Maximum current: 0.5 A
• Mounting hole diameter: 7 mm
• Thread: M7 × 0.75
• Weight: 3.5 g

Scope of Delivery:

• 1× button red
• 1× M7 nut
• 1× spring washer