LED Switch Red IP67 Stainless Steel 19mm

This DFRobot push button (type LAS1-AGQ) has a stainless steel housing, a flat round front and a red illuminated LED ring. It is mounted in a 19 mm hole and is protected against dust and water according to IP67. The LED ring runs on 5 to 12 V and shows, for example, whether a device is switched on.

Note: This switch latches and stays in the pressed position until it is released by pressing it again.

Important: The contacts are rated for 5 A at 250 V AC. Working with 230 V is dangerous and can be fatal. Installation and connection belong in the hands of a qualified person.

Features:

• Stainless steel housing, protection class IP67
• Flat round front with red LED ring
• LED ring for 5 V to 12 V
• Terminals for normally open (NO), normally closed (NC) and common contact as well as plus and minus of the LED
• Mounting with M19 nut and sealing ring

Application Examples:

• Control panels on devices and housings
• On/off switch with status indication
• Outdoor controls
• Controls on machines and in the workshop

Technical Data:

• Manufacturer: DFRobot
• Manufacturer SKU: FIT0115-R
• Type: LAS1-AGQ
• Mounting diameter: 19 mm
• Protection class: IP67
• Switching capacity: 5 A / 250 V AC
• Service life: 40,000 hours
• LED ring: red, 5 V to 12 V
• Contact resistance: ≤ 50 mΩ
• Insulation resistance: ≥ 1000 MΩ
• Dielectric strength: 2000 V AC
• Mechanical life: 1,000,000 operations
• Electrical life: 50,000 operations
• Panel thickness: 1 mm to 10 mm
• Material: stainless steel housing, PBT base
• Operating temperature: -20 °C to 70 °C
• Dimensions: 22 × 22 × 38 mm
• Weight: 30 g

Scope of Delivery:

• 1× LED switch red IP67 stainless steel 19mm
• 1× M19 nut
• 1× O-ring seal