Hard Tough Resin Blue 500g UV 405nm eSun

The eSun Hard Tough Resin is a resin for LCD and DLP resin printers at 405 nm. It cures into parts with high strength, hardness and toughness, comparable to ABS. This makes it suitable for mechanically stressed parts such as gears, brackets, buckles and fasteners. The resin is supplied in a light-tight aluminium bottle.

Recommended Accessories:

• Nitrile Protective Gloves L 100-pack
• Creality Resin Filter 20 Pieces
• 1 Liter Isopropyl Alcohol/Isopropanol 99.8%
• eCure Lite Foldable Resin Curing System

Features:

• For LCD and DLP printers at 395 to 405 nm
• Shore hardness 81D, scratch resistant
• Good tensile, flexural and impact values
• High surface hardness and wear resistance
• Good moisture resistance
• Light-tight aluminium bottle for long storage
• Shake before use, not too hard so that no air bubbles form. Avoid direct sunlight during processing
• Wear gloves, ventilate the room well, keep away from children, in case of skin contact wash immediately with plenty of water
• Clean finished models for about 30 seconds in high-percentage alcohol (above 95 %)

Application Examples:

• Gears and mechanical parts
• Brackets, buckles and fasteners
• Functional parts that need to withstand more than standard resin

Technical Data:

• Manufacturer: eSun
• Type: Hard Tough Resin
• Colour: Blue
• Content: 500 g
• Wavelength: 395 nm to 405 nm
• Exposure time first layers: 30 s to 45 s
• Exposure time normal layers: 8 s
• The exposure times are guide values and depend on the printer
• Printing temperature: 18 °C to 35 °C
• Storage temperature: 15 °C to 35 °C
• Density: 1.1 g/cm³ to 1.15 g/cm³
• Viscosity at 25 °C: 200 mPa·s to 300 mPa·s
• Flexural strength: 70 MPa to 80 MPa
• Flexural modulus: 1300 MPa to 1400 MPa
• Tensile strength: 55 MPa to 60 MPa
• Elongation at break: 25 % to 35 %
• Hardness: 81 Shore D
• IZOD impact strength: 67 J/m to 100 J/m

Scope of Delivery:

• 1× Hard Tough Resin Blue 500 g