Fermion HCHO Formaldehyde Analog Gas Sensor
This Fermion gas sensor from DFRobot detects formaldehyde (HCHO) in the range 0 to 3 ppm. The MEMS sensor sits on a small 13 × 13 mm board, draws less than 20 mA and outputs an analog voltage that changes with the gas concentration. It measures qualitatively: it shows whether the gas is present and whether the concentration rises or falls, but does not provide a calibrated value in ppm.
For calibrated readings, the Gravity SFA40 Formaldehyde Sensor is suitable.
Important: According to DFRobot, the sensor is not intended for systems on which the safety of persons depends, for example as a gas alarm. Remove the protective film before use. Let it preheat for at least 5 minutes when switched on for the first time, and for at least 24 hours after longer storage. Silicone vapours, water and condensation damage the sensor.
Features:
- MEMS gas sensor for formaldehyde (HCHO)
- Analog output, pins A, VCC and GND
- Short preheating time, fast response and recovery
- Current consumption below 20 mA, low heat generation
- 13 × 13 × 2.5 mm board with pin header for soldering
- Can be combined with the other sensors of the Fermion MEMS series (11 gases)
Application Examples:
- Air purifiers and ventilation systems
- Monitoring indoor air after renovation, painting or new furniture
- Portable air quality indicators
Documentation:
- Wiki DFRobot SEN0563
- Example code for Arduino (DFRobot Wiki)
- Datasheet (ZIP)
- Schematic (ZIP)
- Practical test of the Fermion MEMS gas sensors (DFRobot Blog)
Technical Data:
- Manufacturer: DFRobot
- Manufacturer SKU: SEN0563
- Gas: Formaldehyde (HCHO)
- Measuring range: 0 to 3 ppm
- Operating voltage: 3.3 to 5 V
- Current consumption: below 20 mA
- Output: analog voltage
- Load resistance RL: 10 kΩ
- Sensitivity: R0 (air) / Rs (0.4 ppm HCHO) ≥ 1.8
- Preheating time: over 5 min when first switched on, 24 h after longer storage
- Operating temperature: -10 to 50 °C
- Operating humidity: 15 to 90 %RH, non-condensing
- Service life: at least 3 years in air
- Pins: A (analog output), VCC, GND
- Dimensions: 13 × 13 × 2.5 mm
- Weight: 6.3 g
Scope of Delivery:
- 1× Fermion MEMS formaldehyde sensor
- 1× pin header 2.54 mm, 10-pin, for soldering
Fermion HCHO Formaldehyde Analog Gas Sensor
- Brand: DFRobot
- Product Code: 423535
- Availability: In Stock
-
CHF8,90
- Ex Tax: CHF8,23
Related Products
Fermion CO Carbon Monoxide Analog Gas Sensor
This Fermion gas sensor from DFRobot detects carbon monoxide (CO) in the range 5 to 5000 ppm. The ME..
CHF8,90 Ex Tax: CHF8,23
Fermion smoke analog gas sensor
This Fermion gas sensor from DFRobot detects smoke and ethanol in the range 10 to 1000 ppm. The MEMS..
CHF8,90 Ex Tax: CHF8,23
Fermion H2S Hydrogen Sulfide Analog Gas Sensor
This Fermion gas sensor from DFRobot detects hydrogen sulphide (H2S), as well as benzene in the rang..
CHF11,90 Ex Tax: CHF11,01
Fermion NH3 Ammonia Analog Gas Sensor
This Fermion gas sensor from DFRobot detects ammonia (NH3) in the range 1 to 300 ppm. The MEMS senso..
CHF11,90 Ex Tax: CHF11,01
Fermion VOC Analog Gas Sensor
This Fermion gas sensor from DFRobot detects volatile organic compounds (VOC) such as ethanol, forma..
CHF8,90 Ex Tax: CHF8,23
Fermion CH4 Methane Analog Gas Sensor
This Fermion gas sensor from DFRobot detects methane (CH4), propane (C3H8) and other combustible gas..
CHF8,90 Ex Tax: CHF8,23
Fermion EtOH Ethanol Analog Gas Sensor
This Fermion gas sensor from DFRobot detects ethanol (EtOH), i.e. alcohol vapour in the range 1 to 5..
CHF8,90 Ex Tax: CHF8,23
Fermion Odor odor gas analog gas sensor
This Fermion gas sensor from DFRobot detects odour gases such as hydrogen sulphide (H2S), ethanol an..
CHF8,90 Ex Tax: CHF8,23
Fermion NO2 Nitrogen Dioxide Analog Gas Sensor
This Fermion gas sensor from DFRobot detects nitrogen dioxide (NO2) in the range 0.1 to 10 ppm. The ..
CHF11,90 Ex Tax: CHF11,01
Fermion H2 Hydrogen Analog Gas Sensor
This Fermion gas sensor from DFRobot detects hydrogen (H2) in the range 0.1 to 1000 ppm. The MEMS se..
CHF16,90 Ex Tax: CHF15,63
Gravity SFA40 Formaldehyde Sensor
The Gravity SFA40 from DFRobot measures formaldehyde (HCHO) with the electrochemical SFA40 sensor fr..
CHF52,90 Ex Tax: CHF48,94
X6 Environmental Sensor Module 6-in-1 HCHO TVOC CO with UART
The X6 Environmental Sensor Module from Waveshare is a compact 6-in-1 gas sensor module with UART in..
CHF45,90 Ex Tax: CHF42,46
Tags: Formaldehyde, HCHO, gas sensor, air quality, MEMS, monitoring, HVAC, portable, sensor, air purifier, health monitoring, indoor, aldehydes, DFRobot, Analog, Gas, SEN0563, Fermion
















