Gravity IR Kit for Arduino

The Gravity IR Kit from DFRobot consists of an infrared remote control with 21 buttons and the digital IR receiver DFR0094 for 38 kHz. The receiver is connected to a digital pin of the Arduino with the Gravity cable and passes on the signals of the remote control. Each button sends its own code, the list is in the wiki. With the right decoder in the program, the receiver also picks up commands from other IR remote controls.

Note: The connection cable can be converted to male pins with a Dupont cable M-M, so that it also fits an Arduino UNO.

Recommended Accessories:

Features:

Remote control with 21 buttons, CR2025 button cell inserted
Digital IR receiver for 38 kHz, Gravity module DFR0094
Gravity connector PH2.0 3-pin, cable included
Button codes and example code for Arduino in the wiki

Application Examples:

Controlling a robot vehicle with the remote control
Remote control of lights, motors or curtains
Input for your own devices without buttons on the housing

Documentation:

Technical Data:

Manufacturer: DFRobot
Manufacturer SKU: DFR0107
Receiver: Gravity Digital IR Receiver DFR0094
Receiver supply: 5 V
Output: digital
Carrier frequency: 38 kHz
Connector: Gravity PH2.0 3-pin
Cable: 30 cm, red VCC, black GND, green signal, 3-pin socket at the other end
Remote control: 21 buttons, CR2025 button cell
Weight: 24 g

Scope of Delivery:

1× IR remote control with CR2025 button cell
1× Gravity Digital IR Receiver DFR0094
1× Gravity connection cable 3-pin, 30 cm

Safety and Disposal Instructions

This battery is non-rechargeable and should not be charged. Do not short-circuit, open or heat. Keep out of reach of children - especially button cells can cause serious injuries if swallowed; in this case, seek medical help immediately.

Disposal: Batteries do not belong in household waste. Free return to us or any point of sale - see details Return & Disposal.