Fermion 3.5 Inch TFT LCD Capacitive Touchscreen with MicroSD Slot 480x320

The Fermion display module from DFRobot has 3.5 inches, 480 × 320 pixels and a capacitive touch with up to 5 points. The image is driven by the ILI9488 via SPI, the touch by the GT911 via I2C. There is also a slot for microSD cards, for example for images. It runs on 3.3 to 5 V with Arduino UNO, Leonardo, ESP32, ESP8266 and FireBeetle. On the FireBeetle ESP32-E and M0 it is connected via the GDI socket with the included flat cable, without single wires.

With an IPS display there is the 3.5 Inch IPS Capacitive Touchscreen with GDI Port 480x320.

Recommended Accessories:

• 256MB microSD Card
• FireBeetle 2 Board ESP32-E
• FireBeetle Board ESP32-E with soldered socket strips

Features:

• Capacitive touch with up to 5 points, two-finger gestures possible
• 480 × 320 pixels, 16-bit colour (RGB565)
• 4-wire SPI or GDI socket for FireBeetle
• microSD card slot, card not included
• Backlight switchable via the BL pin
• Viewing angle 60° in all directions according to DFRobot

Application Examples:

• User interfaces for IoT controls
• Small game consoles
• Desk display for appointments and notifications

Documentation:

• DFRobot Wiki DFR0669
• DFRobot_GDL library (GitHub)
• Schematic (PDF)
• Datasheet (PDF)

Technical Data:

• Manufacturer: DFRobot
• Manufacturer SKU: DFR0669
• Operating voltage: 3.3 to 5 V
• Driver chip: ILI9488
• Touch chip: GT911, I2C
• Resolution: 480 × 320 pixels
• Pins: VCC, GND, SCLK, MOSI, MISO, CS, RES, DC, BL, SCL, SDA, INT, SDCS
• Brightness: 300 cd/m² typical
• Current full screen: 48.1 mA typical at 3.3 V and at 5 V
• Operating temperature: -20 to 70 °C
• Display area: 73.44 × 48.96 mm
• Mounting holes: 2 mm, spacing 50 × 90 mm
• Dimensions: 55.5 × 95 × 7 mm
• Weight: 62 g

Scope of Delivery:

• 1× Fermion 3.5 inch TFT LCD capacitive touchscreen with MicroSD slot 480x320
• 1× Pin header 1 × 14
• 1× GDI flat cable FPC 0.5 mm 18-pin, 10 cm, for FireBeetle M0 or ESP32-E