LilyGo T-Display ESP32 16MB CH9102F with 1.14 Inch Display

The LilyGo T-Display is a development board with an ESP32 (dual-core Xtensa LX6), Wi-Fi and Bluetooth, 16 MB flash and a 1.14 inch IPS colour display with 135 × 240 pixels. The display with the ST7789 controller is connected to the SPI bus. The board is programmed and powered via USB-C and the CH9102F USB-to-serial chip. A 3.7 V LiPo battery can be connected to the JST 1.25 mm connector and is charged by the TP4054 charging chip.

Recommended Accessories:

• LilyGo T-Display Case ABS
• USB 3.0 Type C Cable 1m black

Features:

• ESP32, dual-core Xtensa LX6, 16 MB flash
• Wi-Fi 802.11 b/g/n and Bluetooth 4.2 with BLE
• IPS display 1.14 inch, 135 × 240 pixels, ST7789 controller via SPI, backlight on GPIO4
• Two buttons on GPIO0 and GPIO35
• USB-C with CH9102F USB-to-serial chip
• JST 1.25 mm connector for a 3.7 V LiPo battery, TP4054 charging chip
• Programming with Arduino or MicroPython

Application Examples:

• Small displays for measured values and states
• Control units and status displays in the smart home
• Portable battery-powered devices
• Integration into Home Assistant with ESPHome

Documentation:

• T-Display on GitHub (LilyGo, English)
• ESPHome documentation: MIPI SPI Display Driver

Technical Data:

• Manufacturer: LilyGo
• Manufacturer SKU: Q125
• Microcontroller: ESP32
• CPU: Xtensa dual-core LX6
• Flash: 16 MB
• Radio: Wi-Fi 802.11 b/g/n, Bluetooth 4.2 with BLE
• Display: IPS, 1.14 inch, 135 × 240 pixels, ST7789
• Buttons: GPIO0, GPIO35
• USB-to-serial chip: CH9102F
• Charging chip: TP4054
• Connector: USB-C
• Dimensions: 53 × 25 × 5 mm
• Weight: 21 g

Scope of Delivery:

• 1× LilyGo T-Display ESP32 16MB CH9102F with 1.14 Inch Display
• 1× JST 1.25 mm 2-pin cable, 10 cm
• 2× pin header 12-pin