Creality Thermistor Repair Kit

This repair kit contains a Creality thermistor with a glass-sealed tip and two heat-shrink solder connectors. For the replacement, the wires of the old sensor are cut off and stripped. The ends are pushed into the solder connectors and heated with hot air at about 250 °C: the solder in the middle melts and joins the wires, the heat-shrink tubing insulates the joint.

If the temperature sensor is defective, the printer shows a temperature that is too high or too low or reports «Thermal Runaway».

Recommended Accessories:

• 50 Piece Heat Shrink Solder Connector Set 0.25-6mm²
• Electronics side cutters
• FS-D3 Automatic Wire Stripper 0.08-6mm2
• Polyimide heat-resistant adhesive tape 20mm x 30 meters

Features:

• Original Creality spare part
• For hotend or heated bed
• Glass-sealed sensor tip
• With 2 heat-shrink solder connectors for connecting to the existing wires
• Fits on the hotend of: Ender-3, Ender-3 Pro, Ender-3S-B, Ender-3 V2, Ender-3 Max, Ender-5, Ender-5S, Ender-5 Pro, Ender-5 Plus, Ender-6, CR-10, CR-10S, CR-10 V2, CR-10 V3, CR-10 S4, CR-X, CR-X Pro, CR-10 Max, CR-10S Pro, CR-10S Pro V2, CR-2020, CR-30, CR-5 Pro
• Fits on the heated bed of: Ender-3, Ender-3 Pro, Ender-3S-B, Ender-3 V2, Ender-3 Max, Ender-5, Ender-5S, Ender-5 Pro, Ender-5 Plus, Ender-6, CR-X, CR-X Pro, CR-10 Max, CR-10S Pro, CR-10S Pro V2, CR-2020, CR-6 SE, CR-6 Max, CR-20, CR-20 Pro, Sermoon D1

Application Examples:

• Replacing a defective temperature sensor on the hotend
• Replacing a defective temperature sensor on the heated bed

Technical Data:

• Manufacturer: Creality
• Manufacturer number: 4004070029
• Measuring range: -30 to 300 °C
• Cable length: 300 mm
• Weight: 6.5 g

Scope of Delivery:

• 1× Creality thermistor
• 2× Heat-shrink solder connector