20Kg Load Cell Weight Sensor

This aluminium load cell measures weight up to 20 kg. Together with an HX711 load cell amplifier, scales and other weight measurements can be built with Arduino, ESP32 or Raspberry Pi. The cell is a full bridge with 4 wires and is connected directly to the HX711.

Recommended Accessories:

• Load Cell Amplifier - HX711 Weighing Sensor 24 Bit
• Dupont Jumper Cable Set 20cm 60 Pieces.

Features:

• Full bridge with 4 wires: red, black, white, green
• The arrow on the end face shows the direction of the load
• 2 M4 threaded holes at each end: one end on the base plate, the weighing plate on the other end
• Leave the measuring point in the middle free, fasten only the ends

Application Examples:

• Kitchen, letter and parcel scales
• Monitoring the fill level of containers via the weight
• Measuring weight and weight changes

Documentation:

• Scale with HX711 and Arduino, with calibration (Random Nerd Tutorials)
• Raspberry Pi scale with HX711 (Tutorials for Raspberry Pi, German)
• HX711 guide (SparkFun, different module with the same chip)

Technical Data:

• Maximum weight: 20 kg
• Design: bar, full bridge
• Connection to the HX711: red to E+, black to E-, white to A-, green to A+. If the reading falls under load, swap A+ and A-
• Length of connection wires: 15 cm
• Mounting holes: 4× M4
• Dimensions: 75 × 12.6 × 12.6 mm
• Weight: 29.8 g

Scope of Delivery:

• 1× 20Kg Load Cell Weight Sensor