Fermion CO Carbon Monoxide Analog Gas Sensor

This Fermion gas sensor from DFRobot detects carbon monoxide (CO) in the range 5 to 5000 ppm. The MEMS sensor sits on a small 13 × 13 mm board, draws less than 20 mA and outputs an analog voltage that changes with the gas concentration. It measures qualitatively: it shows whether the gas is present and whether the concentration rises or falls, but does not provide a calibrated value in ppm.

For calibrated readings, the Gravity CO Sensor 0-1000ppm I2C and UART is suitable.

Important: According to DFRobot, the sensor is not intended for systems on which the safety of persons depends, for example as a gas alarm. Remove the protective film before use. Let it preheat for at least 5 minutes when switched on for the first time, and for at least 24 hours after longer storage. Silicone vapours, water and condensation damage the sensor.


Features:

  • MEMS gas sensor for carbon monoxide (CO)
  • Analog output, pins A, VCC and GND
  • Short preheating time, fast response and recovery
  • Current consumption below 20 mA, low heat generation
  • 13 × 13 × 2.5 mm board with pin header for soldering
  • Can be combined with the other sensors of the Fermion MEMS series (11 gases)

Application Examples:

  • Experiments on combustion and exhaust gases
  • CO detection in industry, mining and metalworking (DFRobot)
  • Combination with other Fermion MEMS sensors in measuring modules

Documentation:


Technical Data:

  • Manufacturer: DFRobot
  • Manufacturer SKU: SEN0564
  • Gas: Carbon monoxide (CO)
  • Measuring range: 5 to 5000 ppm
  • Operating voltage: 3.3 to 5 V
  • Current consumption: below 20 mA
  • Output: analog voltage
  • Load resistance RL: 4.7 kΩ
  • Sensitivity: R0 (air) / Rs (150 ppm CO) ≥ 3
  • Preheating time: over 5 min when first switched on, 24 h after longer storage
  • Operating temperature: -10 to 50 °C
  • Operating humidity: 15 to 90 %RH, non-condensing
  • Service life: at least 5 years in air
  • Pins: A (analog output), VCC, GND
  • Dimensions: 13 × 13 × 2.5 mm
  • Weight: 7.2 g

Scope of Delivery:

  • 1× Fermion MEMS carbon monoxide sensor
  • 1× pin header 2.54 mm, 10-pin, for soldering

Write a review

Note: HTML is not translated!
    Bad           Good

Fermion CO Carbon Monoxide Analog Gas Sensor

  • Brand: DFRobot
  • Product Code: 423533
  • Availability: In Stock
  • CHF8.90

  • Ex Tax: CHF8.23

Related Products

Gravity CO Sensor 0-1000ppm I2C and UART

Gravity CO Sensor 0-1000ppm I2C and UART

This Gravity gas sensor from DFRobot measures carbon monoxide (CO) with an electrochemical cell in t..

CHF69.90 Ex Tax: CHF64.66

Fermion smoke analog gas sensor

Fermion smoke analog gas sensor

This Fermion gas sensor from DFRobot detects smoke and ethanol in the range 10 to 1000 ppm. The MEMS..

CHF8.90 Ex Tax: CHF8.23

Fermion HCHO Formaldehyde Analog Gas Sensor

Fermion HCHO Formaldehyde Analog Gas Sensor

This Fermion gas sensor from DFRobot detects formaldehyde (HCHO) in the range 0 to 3 ppm. The MEMS s..

CHF8.90 Ex Tax: CHF8.23

Fermion H2S Hydrogen Sulfide Analog Gas Sensor

Fermion H2S Hydrogen Sulfide Analog Gas Sensor

This Fermion gas sensor from DFRobot detects hydrogen sulphide (H2S), as well as benzene in the rang..

CHF11.90 Ex Tax: CHF11.01

Fermion NH3 Ammonia Analog Gas Sensor

Fermion NH3 Ammonia Analog Gas Sensor

This Fermion gas sensor from DFRobot detects ammonia (NH3) in the range 1 to 300 ppm. The MEMS senso..

CHF11.90 Ex Tax: CHF11.01

Fermion VOC Analog Gas Sensor

Fermion VOC Analog Gas Sensor

This Fermion gas sensor from DFRobot detects volatile organic compounds (VOC) such as ethanol, forma..

CHF8.90 Ex Tax: CHF8.23

Fermion CH4 Methane Analog Gas Sensor

Fermion CH4 Methane Analog Gas Sensor

This Fermion gas sensor from DFRobot detects methane (CH4), propane (C3H8) and other combustible gas..

CHF8.90 Ex Tax: CHF8.23

Fermion EtOH Ethanol Analog Gas Sensor

Fermion EtOH Ethanol Analog Gas Sensor

This Fermion gas sensor from DFRobot detects ethanol (EtOH), i.e. alcohol vapour in the range 1 to 5..

CHF8.90 Ex Tax: CHF8.23

Fermion Odor odor gas analog gas sensor

Fermion Odor odor gas analog gas sensor

This Fermion gas sensor from DFRobot detects odour gases such as hydrogen sulphide (H2S), ethanol an..

CHF8.90 Ex Tax: CHF8.23

Fermion NO2 Nitrogen Dioxide Analog Gas Sensor

Fermion NO2 Nitrogen Dioxide Analog Gas Sensor

This Fermion gas sensor from DFRobot detects nitrogen dioxide (NO2) in the range 0.1 to 10 ppm. The ..

CHF11.90 Ex Tax: CHF11.01

Fermion H2 Hydrogen Analog Gas Sensor

Fermion H2 Hydrogen Analog Gas Sensor

This Fermion gas sensor from DFRobot detects hydrogen (H2) in the range 0.1 to 1000 ppm. The MEMS se..

CHF16.90 Ex Tax: CHF15.63

Fermion BME688 AI Environmental Sensor (VOC, Temperature, Humidity, Pressure)

Fermion BME688 AI Environmental Sensor (VOC, Temperature, Humidity, Pressure)

The Fermion BME688 from DFRobot is a small breakout with the Bosch BME688 for temperature, humidity,..

CHF14.90 Ex Tax: CHF13.78

Gravity SFA40 Formaldehyde Sensor

Gravity SFA40 Formaldehyde Sensor

The Gravity SFA40 from DFRobot measures formaldehyde (HCHO) with the electrochemical SFA40 sensor fr..

CHF52.90 Ex Tax: CHF48.94

Tags: Carbon monoxide, gas sensor, MEMS, CO, environmental protection, operating voltage, monitoring, air quality, gas, DFRobot, SEN0564, Fermion