USBasp AVR Programmer USB ISP with Adapter Plug

With this USB ISP programmer, you can program Atmel microcontrollers via the ISP interface. The programming adapter is very helpful for changing the firmware on a 3D printer like the Ender 3. Since usually the firmware cannot be flashed via the USB port for the first time, you can simply copy the firmware to the printer via the ISP port with this adapter. The programmer can program 5V or 3.3V microcontrollers. Simply set the correct voltage via the jumper on the adapter.


Drivers for USBasp:


Technical Details:

  • Chip: Atmega8L
  • Number of pins: 10
  • Cable length: 20cm
  • Dimension: 63 x 20.5 x 10.5mm
  • Weight: 18.5g

Delivery contents:

  • 1x USBASP AVR Programmer USB ISP with adapter connector
  • 1x 10 pin cable
  • 1x adapter to 6 pin ISP


Write a review

Note: HTML is not translated!
    Bad           Good

USBasp AVR Programmer USB ISP with Adapter Plug

  • Brand: purecrea
  • Product Code: 421051
  • Availability: In Stock
  • CHF13.90

  • Ex Tax: CHF12.86

Related Products

Mini USB UART FTDI Programmer 3.3/5V USB Serial

Mini USB UART FTDI Programmer 3.3/5V USB Serial

This Breakout Board FTDI is equipped with a FT232RL chip that allows USB to Serial communication. Yo..

CHF9.90 Ex Tax: CHF9.16

Sparkfun Pocket AVR Programmer

Sparkfun Pocket AVR Programmer

This is a simple-to-use USB AVR programming device. It's affordable, easy to use, works excellently ..

CHF22.90 Ex Tax: CHF21.18

DAPLink ARM Programmer Emulator

DAPLink ARM Programmer Emulator

This DAPLink programmer is required for the firmware update of some Dragino Nodes. The adapter can a..

CHF17.90 Ex Tax: CHF16.56

Tags: Atmega, AVR, ISP, Programmer, Arduino, bootloader, Ender, Creality, Ender3, Marlin