Installation pressure button red 7mm 2P

This inexpensive red push button/switch is great for your DIY Arduino projects. If you activate the pull-up resistor on an input on your Arduino, you can connect the push button to this input and GND. If the button is not pressed, the signal is at 1, as soon as the button is pressed, the input drops to 0.

Info: When soldering, do not apply too much heat for too long, as this may melt the plastic and destroy the button.

Technical Details:

• Color: Red
  
• Material: Plastic / Galvanized Metal
  
• Switch Contact: NO (normally open)
  
• Contact: Soldering
  
• Number of Pins: 2
  
• Maximum Voltage: 50V
  
• Maximum Current: 0.5A
  
• Hole Diameter for Installation: 7mm
  
• Weight: 3.5g
  

Delivery Includes:

• 1x Red Push Button
  
• 1x M7 Nut
  
• 1x Spring Washer