ABS+ Yellow Filament 1.75mm 1Kg eSun

ABS Plus from eSun is an enhanced ABS filament that prints much better and has only very little warping. ABS+ is for advanced users, is easy to print compared to standard ABS and also gives you good adhesion properties and almost no warp effect when printing! ABS+ is the alternative to ABS. ABS+ has very good toughness and impact resistance to withstand falls, impacts and breaks through stretching. The printed surface of ABS+ cannot be smoothed afterwards with solvents. However, ABS+ can be better mechanically reworked with, for example, sandpaper.

Characteristics:

• Highly resilient
• Reliable bed adhesion
• Lower shrinkage rate therefore also less warping
• Optimal layer adhesion
• Good impact resistance
• Resistant to many oils

ABS+ recommended print parameters:

• Print temperature: 220-260°C Recommended: 240°C
• Heated bed Temperature: 100°C
• Fan speed: 0 to 20% Recommendation: 15% or turned off
• Feed speed: 40-60mm/s (2400-3600mm/min)

Download:

• eSun Product Manual
• Filament Datasheet

Technical details:

• Color: Yellow
• Filament weight: 1Kg
• Diameter: 1.75mm
• Tolerance: +-0.05mm
• Print temperature: 220-260°C
• Density: 1.06g/cm3
• Melt flow index: 15g/10min
• Impact resistance: 42kJ/m²
• Elongation at break: 30%
• Tensile strength: 40MPa
• Thermal stability: Approx. 90°C
• Spool size diameter outside: 20cm
• Spool width: 6.85cm
• Diameter inside (hole): 5.3cm
• Filament weight: 1000g
• Empty spool weight: 229g
• Total weight: 1423g
• Dimension: 205 x 215 x75mm

Package content:

• 1x ABS+ Yellow Filament 1.75mm 1Kg eSun

---