4x18650 Lithium Battery Shield DFrobot 3A 5V/3.3V

This 4-slot 18650 battery compartment from DFRobot has 5x 5V/2A and 3V/1A outputs as well as a 5V USB output. The batteries can be charged via a USB Type-C or micro port. The compartment has LEDs that show you the charging status of the batteries and a DIP switch that can manually cut off the current. With the built-in DIP switch, you can switch between the HOLD and NORMAL modes. In normal mode, the module turns off when the current is too low, while in HOLD mode, it continues to output current and only switches off when the under-voltage protection is activated. 

Warning: When inserting the 18650 lithium batteries, pay attention to the polarity + and –, otherwise the charging chip will be destroyed!

Recommended Accessories:

• 18650 Lithium Battery without Protection Circuit

Features:

• Battery protection for overcharging and deep discharge
• Easy charging via Micro USB or USB Type-C connector
• Side switch for switching on and off (K1)
• 3A 5V USB Type-A output or solder pins (5x5V or 5x 3.3V solder pins available)
• LED indicator 4xRed for charging status

Technical Details:

• Manufacturer: DFRobot 
• Manufacturer SKU: DFR0970 
• Output: 5V/2A or 3V/1A 
• Input: USB Micro or Type-C  
• Dimension: 100 x 90 x 18mm 
• Weight: 72g 
  

Delivery Content:

• 1x 4x18650 Lithium Battery Shield-DFrobot 3A 5V/3.3V  (Batteries are not included)